Ask and answer engineering questions

Learn from millions of experts

Questions and answers

  1. Tiny

    How to select all surfaces between two boundaries?

    By Semih Cetinkaya, 24 Aug 08:17 0 answers 2 views 0 comments
  2. Tiny

    I use a new material for my part.now, I want analysis that and it show error:material type is not supported.check the material defination.how can I solve it?

    By Ali Yousefi, 24 Aug 07:03 0 answers 3 views 0 comments
  3. Missing tiny

    how can i make one surface?

    By sukru yurdakul, 24 Aug 06:31 2 answers 8 views 0 comments
  4. Missing tiny

    how to perform 3-point-bending test in ANSYS APDL?

    By aizatul zahir, 24 Aug 01:57 0 answers 10 views 0 comments
  5. Missing tiny

    how to make abody for rc car from acrylic and cutting it by laser cutting?

    By mostafa x, 24 Aug 00:48 1 answer 12 views 0 comments
  6. Missing tiny

    How to eliminate highlighted border on offset surface part?

    By Spencer Davis, 23 Aug 20:38 1 answer 11 views 1 comment
  7. Missing tiny

    Somebody has a linear carriage MNG 15H ?

    By Rene Aguilar Pazos, 23 Aug 15:29 1 answer 18 views 1 comment
  8. Missing tiny

    How to assemble a rope?

    By Mohammad Hossein yoosefian, 23 Aug 13:18 2 answers 32 views 1 comment
  9. Missing tiny

    In an assembly: How to project a sketch/line onto another angled plane. Perpendicular to the source plane

    By Marc, 23 Aug 08:45 1 answer 30 views 1 comment
  10. Tiny

    how to simulate screw thread stress analysis.

    By rahman alam, 23 Aug 06:28 0 answers 32 views 1 comment
  11. Tiny

    How do I animate this pinion and gear with inventor?

    By Mohammad Abdin, 22 Aug 14:30 1 answer 37 views 0 comments
  12. Missing tiny

    How to create a pattern normal to a curved surface

    By lololamoto, 22 Aug 13:17 2 answers 53 views 1 comment
  13. Missing tiny

    plz convert it to igs

    By siddharth soni, 22 Aug 11:23 1 answer 29 views 0 comments
  14. Missing tiny

    how do i make a personalized weldments profile? in solidworks

    By Jiffy Dioso, 22 Aug 09:30 2 answers 40 views 3 comments
  15. Missing tiny

    How to save .sldlfp from sldprt in solidworks? for my design library

    By Jiffy Dioso, 22 Aug 08:49 1 answer 37 views 0 comments

Save Cancel