I'm modeling some stamping on a pair of pliers and the metric stamping is creating a stepped face the same depth as the wrap feature. The imperial wrap feature across from it worked flawlessly and I can't seem to figure out where I'm going wrong. I've tried moving that particular wrap ahead of the imperial one and it will still create the step on the face. I'd really like to avoid copping out and just using a cut extrude on it. Any insight would be appreciated.
Problem is with a sketch10. Try do it again and fully defined all sketch.
I discovered that the wrap was freaking out once it reached the two slot features so I moved it up in the feature tree to avoid them. However, the wrap feature is terminating at the transition to the bend and not on the bend as on the inch side.