Ask and answer engineering questions

Learn from millions of experts

Missing feed

Cutting surface in Catia V5R20

By Imad Haqqi on 21 Feb 23:00 1 answer 172 views 0 comments

I asked this question at https://grabcad.com/questions/cutting-surface-in-catia-v5r20?utm_campaign=newanswer&utm_content=joinconversation&utm_medium=email&utm_source=member-email
I could not add the tutorial and part model there.

I am trying to cut a surface from a sweep geometry in a block. I am getting the error
"A skin does not cut across one of the volume: the split cannot be computed"
I have attached the two images. Please advise how I can remove this error. I shall be grateful.
Thanks

Added images

Square Square

Attachments

cabinet_a_1.CATPart, 99.8 KB
Download
Tut01-e-Excavator.pdf, 4.86 MB
Download

1 answer

  • Jack Knapp
    Jack Knapp 7 months ago

    That message means the surface does not fully intersect the solid. Either make the surface bigger, or make the solid smaller.

Add your answer to: "Cutting surface in Catia V5R20"

Save Cancel