Ask and answer engineering questions

Learn from millions of experts

Missing feed

Cutting surface in Catia V5R20

By Imad Haqqi on 21 Feb 23:04 1 answer 1 comment

I asked this question at
I could not add the tutorial and part model there.

Please refer to Tutorial 1-B from Page 28.
I am trying to cut a surface from a sweep geometry in a block. I am getting the error
"A skin does not cut across one of the volume: the split cannot be computed"
I have attached the two images. Please advise how I can remove this error. I shall be grateful. Thanks

Added images

Square Square


Tut01-e-Excavator.pdf, 4.86 MB
cabinet_a_1.CATPart, 99.8 KB

1 answer

Add your answer to: "Cutting surface in Catia V5R20"

Save Cancel