Ask and answer engineering questions

Learn from millions of experts

Missing feed

Drafting Injection Mould Tool GA Drawings

By Trevor Sheen on 09 Mar 13:40 1 answer 0 comments

Just looking for some advice on how to draft injection mould tool General Assembly (GA) drawings.

I want to include a full BOM and enough detail for machinists to understand without over complicating things.

I have seen drawings produced using other software with lines removed etc and they look nice and clear. The issue I find with SW is that it's very time consuming to remove all detail I don't want, therefore just seeking some guidance on ways to carry out the task in hand.

Some examples of what others have produced in SW would be useful.

Thanks.

1 answer

  • Donțu Daniel Nicolae
    Donțu Daniel Nicolae about 2 years ago

    If you want you can include on the same paper the entire assembly on the same page, if you use a big format like A0 or at least A1, an then use a detailed view or a section throw the general assembly for a better understanding of the injection mould.

Add your answer to: "Drafting Injection Mould Tool GA Drawings"

Save Cancel