Ask and answer engineering questions

Learn from millions of experts

Missing feed

How could a 3D sketch be achieved in CREO ? (as below)

By TeySteer on 25 May 16:05 1 answer 5298 views 2 comments

1 answer

  • Evan R
    Evan R about 2 years ago

    The way I do it, I create an offset coordinate point system, and then you create a datum curve. Then you use the datum curve for your trajectory on your sweep or swept blend.

    It is a lot more steps with Creo than with Solidedge.

    Hope this helps

    Attachments

    lacking3dcurves.prt.1, 171 KB
    Download

Add your answer to: "How could a 3D sketch be achieved in CREO ? (as below)"

Save Cancel