Shuchon

How do i emboss in the surface of a torus in inventor? Is this even possible?

Question by Shuchon

I'm trying to emboss a text on the surface of a torus. It seems impossible. Is this possible with inventor 2013? if not, then which software is capable of that?

Answer
 
Comments 0

3 Answers

Tomek F.
Answered on 18 Oct, 2013 12:17 AM

but perhaps a little curiosity
and probably in your program, it is possible
The same happens with other geometries of the text above

 
Comments 1
Shuchon
Answered on 18 Oct, 2013 12:33 PM

The procedure I followed to solve the problem was as below...(Just if any one is interested)
1. Offset surface
2. Extrude the text up to surface from a plane above surface.
3. Cut the above portion using Split-->Trim Solid Command.

 
Comments 0