How do you emboss/wrap onto a multi-directional curved surface in Solidworks?

How do you emboss/wrap onto a multi-directional curved surface in Solidworks?

Answer
 
Comments 0

4 Answers

Unless it's a cylinder, the wrap won't work. You can use the offset from surface or up to surface as an "edn" condition but depending on your geometry it can get tricky...

 
Comments 0

Extrude upto that surface and offset the surface. Now use offseted surface to cut with surface..

 
Comments 0

Was googling, having trouble, found this. Sharing my solution. Had draft on plastic part needed sketch to be added for printing. Wrap does work even after I tried by adding a "tangent" plane with the draft. So instead I projected from that plane but I could only project one entity at a time. At least so far this is my solution.

 
Comments 0

I have the same problem.
I am designing a shoe mould which has multiple degrees of curvature and need to wrap my clients logo to the curved faces.
I am using SolidWorks 2012, are there any softwares that address this?

 
Comments 0