How to Constrain a Driveshaft in Inventor 2013

Hey guys, I am working on a model rc car and I am having some problems constraining a drive shaft. I believe it is called a dogbone type of shaft and I am trying to constrain it into the cup. I attached a picture of what I am trying to do. I cannot seem to get both sides constrained properly because they are not directly in line and are not level. The shaft will fit between them , but I just cant seem to constrain it there. Thanks for any help.

Answer
 
Comments 0

2 Answers

Hello man,

Give me the parts in inventor 2012 format and I will contrain them and make printscreens step by step to show how to do it, If you are ok with this method of course.

Regards,
Cris Nutescu

 
Comments 0