HEllo there guys.
I have a question. Is there any way that i could flatten a surface in solidworks?? I have a curved surface and i would like to get a flat patern so that i can lasercut it.
Thank you in advance!
From 2015, this is available within SldWks
Check this too
AttachmentsPart2.SLDPRT, 155 KB
no thats not the right way to sort out the problem bro
just measured the arc length and made exactly on the plane... after that i plotted arc at end points of lines and applied appoximate radii of the curvature of the plane... :)
There is some error in the area +- but you can get a simple idea. :)
how did you do this bro/??