yo yo

Need help redimensioning this

Question by yo yo

I've been stuck for hours trying to redimension these parts to match the photos attached. Any help is appreciated

Answer
 
Comments 0

2 Answers

FredSWUG
Answered on 3 Dec, 2017 05:29 AM

To start, change your units from mm to inches.

Changing the part should be as easy as editing the sketches and typing in the new values. Screenshot attached.
I'd upload a model, but you have SW2013 and would not be able to open it.

Where are you getting stuck?

Other things:
- The chamfer should only be applied to two edges, not four.
- The cosmetic threads look hideous. I'd delete it unless it is a requirement.
- The blind hole in the end is a 10-32. NOT a 3/8-16

 
Comments 1
yo
yo
Answered on 5 Dec, 2017 07:56 PM