PIPES ROUTING MISTAKE

DEAR ALL , I MAKE A FAULT THAT I OPEN THE PIPES FITTINGS ( REDUCED TEE ) FROM MY ASSEMBLY AND BY MISTAKE I DELETE SOME FEATURES , AND SAVE WITHOUT NOTICE. NOW WHEN I TRY TO ADD THE FITTINGS , IT LACKS ITS NECK , AND THE OUTLET ROUTE EXTROSION.... SO HOW I CAN RETURN IT BACK

Answer
 
Comments 0

1 Answer

1. Start by turning off the Caps Lock key on your keyboard.
2. You can't return it back. The features were deleted, then saved. The software figured that was what you wanted to do.
3. Rebuilding the missing feature(s) is most likely what will need to happen.
4. IF you are lucky, the SolidWorks backup setting will be turned on, and it will be working. Go to Tools - Options - System Options - Backup/Recovery Is there a folder specified? Is the Number of backup copies set to a number higher than 1? Check it out and see if you have a backup copy.

 
Comments 0