Manjil Puri

Simulate a simply supported beam in Solidworks

Question by Manjil Puri

I want to simulate a simply supported beam with point loads along the length of the beam and two supports.I have provided the sketch of the beam.The beam has a square cross section of 150 *150 mm.Here the vertical lines are the forces equal to 500 N that must be acted on downward direction and the picture also contains distance of the loads the dimension of length are in mm?
PS: Is there any way to simulate the similar structures which has more than two supports

Answer
 
Comments 0

1 Answer

FredSWUG
Answered on 18 May, 2017 02:08 PM

My Toolbox add-in appears to be dead for some reason, but recall it having a beam study module. I'm not sure of its limitations, but check it out and see if it can help.

 
Comments 0