Why is my Plane being added like this?

I add a Plane to two Axis' and one end of the Plane ends up high and the other lower! I have never seen this happen and was wondering if someone could point me in the right direction as to how this is happening?

Comments 0

3 Answers

I saw this happening in SW, but it is not a problem, you can pull at the endpoints of the plane to stretch it to the size you desire.

Comments 2

Here is a picture of the mounting hook that i was making when I asked the question. The mounting hook is the little upside down U that is close to the butt of the 50 cal! I still dont know why the plane was be added all weird though!

Comments 1

What you can do is starting a new sketch on required existing plane and use the endpoints as the refenrence points for the new plane. later simply hide the sketch.

Comments 0