Tutorials

Small

Simulation With Laws in CATIA V5

1 2 Intermediate
This Tutorial explains the steps involved in creating a mechanism in CATIA Assembly Design Workbench, Creating mathematical relations in mechanisms & plotting various graphs like Velocity, Acceleration etc. in mechanisms.
Small

How to analyse any 2D sketch mechanism in solidworks

1 0 Beginner
in this video you will learn how to make any 2d sketch mechanism in solidworks and analyse its various aspects like velocity and acceleration in solidworks by using motion analysis
Small

Tutorial - CATIA DMU Kinematics Jet Engine's Variable Inlet Guide Vanes(VIGV) Simulation

0 0 Intermediate
A gas turbine engine in which the angle of the inlet guide vanes can be changed to meet the requirements of the engine-operating conditions. These are normally in front of the first stage of an axial compressor and sometimes in the subsequent stages as well. Normally, they are closed during engine starting and low RPM, but they open progressively as the RPM is increased. At low RPM, the angle of attack of the low-pressure blades is kept moderate to avoid stalling. Variable-inlet guide vanes are not common in front of the turbine. 3D Design VIGV - https://grabcad.com/library/jet-engine-s-variable-inlet-guide-vanes-vigv-1 3D Design Jet Engine - https://grabcad.com/library/jet-engine-with-afterburner-model-1
Small

domino falling animation in solidworks

0 0 Beginner
domino falling animation in solidworks
Small

Dynamic anti rotating mechanism with piston

0 0 Beginner
Dynamic anti rotating mechanism in solidworks (SUBSCRIBE TO MOTIVATE) Application: it is used to convert clockwise rotation to anticlockwise or vice versa where to use: it is used where u have to convert ur shaft direction suddenly (gear can also be used but this method will get less wear and tear if sudden change in direction occur) https://youtu.be/0ZgtoJNPfCk