Solidworks fails to wrap arc onto cylindrical face
I'm trying to create a curve by wrapping an arc (see Open Sketch.JPG) from one edge of a half-cylinder face to the other.
When I attempt to create the wrap feature, the preview shows exactly what I want, but when I attempt to confirm, Solidworks throws the error "The wrap feature cannot be created from intersecting or open contours." (see Open Wrap Failure.JPG)
I attempted to fix the issue by closing the contour. (see Closed Sketch.JPG)
Again, the preview shows exactly what I want. (see Closed Wrap Preview.JPG)
But the wrap feature ignores the arc and only wraps the straight line. (see Closed Wrap Result.JPG)
Anyone know how I can make this work?
Closed Wrap Result.JPG
Closed Wrap Preview.JPG
Closed Sketch.JPG
Open Wrap Failure.JPG
Open Sketch.JPG
Accepted answer
I found a hacky workaround for the issue. I'm still not entirely sure what Solidworks' problem was, but I discovered while adjusting the dimensions that it didn't like wrapping the arc all the way to the edge of the face, so I created a new full cylinder surface to wrap the closed profile version of the sketch onto.
1 Other answer
It seems to work in SW2020, but who knows how my model and sketches differ from yours? Uploading your model may allow better insight.
Wrap is usually a rarely used command in SW. What are you trying to do/make? There might be a better method. As you have the Scribe option enabled, a Split Line (under the Curves menu) may give the same result.
