Direct experience using NX to do your job

30 May, 2018 12:32 PM

So this topic is as it states, for you to post examples of ways in which you use NX to perform your daily design duties.

Unfortunately... what happens in a lot of 'discussion' forums is people post videos from YouTube. That's fine and dandy but anyone searching "NX 12", "NX 11", etc., can get lost in the sea of that stuff at will.

What they can't get--at least not easily--is an exchange of information with someone using the software every day to get stuff done.

I'll post some examples here later but in the meantime, have at it.

Mustafa Aşan

Jun 1, 2018

Yes, it's a good point. If somebody need specific support, they can ask it under a topic and we all can share our experience about the issue.

andrew ooi

Aug 12, 2018

I'm also NX user, but previously I just the AutoCAD and slowly upgraded my to different CAD user so.

Now I use NX cause of synchronous methods are more simply and friendly use and also can removed all not in use history to reduce file size.

Siemens NX (Unigraphics) Users

Created by Mustafa Aşan on 27 April, 2018

278

6355

Direct experience using NX to do your job