seleshi

how to model a sprocket using solidworks

Question by seleshi

i have a solidworks 2007 and want to model a chain drive.

Answer
 
Comments 0

3 Answers

Mark Holub
Answered on 31 May, 2013 04:32 PM

create a series of extrusions, 1st one being the edge of the sprocket, 2nd one being the teeth, 3rd one being the other side. build it from the side where it looks like an "O".

 
Comments 0
Patrick
Answered on 31 May, 2013 10:41 PM

Hi Seleshi,
why not try to use the toolbox content ? Open a new assembly document, open / activate toolbox and look for this type of part by browsing folders. Insert the part into assembly, adjust parameters (theets number ...), validate and save document as a part file (.sldprt) = it's done.
Hope this will match your request.

 
Comments 0
Dimitri
Answered on 11 Sep, 2013 05:54 AM

I was looking in the toolbox, and find sprockets, however, I would like to make a motorcycle 520 pitch rear sprocket and the toolbox doesn't have any that look near that I can manipulate

 
Comments 0