Some technical issues on current software, hope to hear from good news.
Below is my issues with current software.
Objective is to extract the scan file into either in curve or section to rebuild all the 3d model in proe.
Recently facing some problem to work on STL format file with the current software. even that it able to let me import into the current software, but it hardly for me to extract any curve or cross section to take measure with it.
Currently is using the ProEngineer wildfire 2, although see like recommend by using shrinkwrap in proe. ( The only solution ) but it since like the result is not as good as what I wanted. ( set the resolution to level 10, recommend highest is the best result ). Now still pending for any suggestion ?