Design of a Basic Pin

  1. Step 1: Sketch for the Pin

    Click on sketch command & select line. Then draw the this sketch as given above.

  2. Step 2: Revolve Boss-base

    Now click on Revolve Boss-bass command from the Feature Tab in Command Ribbon. Then, select the blue line as shown in above pic. Then click on done.

  3. Step 3: Sketch for Hole

    Now, select Front plane and sketch a circle as shown above.

  4. Step 4: Extrude cut

    Now, go to Feature Tab and select Extrude- Cut command.

    Then select the direction1 as THROUGH ALL-BOTH.

    Click on OK.