Tutorials

Small

Design of Geneva Wheel Mechanism with MOTION ANALYSIS in UNIGRAPHICS

4 0 Intermediate
A mechanism which used in motion picture film projectors to intermittently advance film through a film gate having a projection aperture. The film is moved or advanced by a Geneva Mechanism (also known as a “Maltese Cross”) until an image frame is in alignment with the projection aperture. Link to join our community: https://www.youtube.com/channel/UCVbjnpjSOH2BrLBYhqdXW4g?sub_confirmation=1
Small

Introduction to Dynamic Simulation [Part 4]

1 0 Beginner
Greetings 3DExperience Fans :) This video is the 4th part of our Introduction to Dynamic Simulation on CATIA 3DExperience R2021x. The topic of this new video is Axial Spring in Mechanism Systems Experience. The example that can well illustrate axial spring is a Ratchet Wheel. In one direction the wheel turn but in the other it is blocked by a pawl and cannot rotate. The spring is essential for the pawl to be in contact with the ratchet wheel. In this demonstration, you will create engineering connections, contacts and a spring. After doing that you will create a Dynamic scenario, but this time no need of gravity excitation, since it will not impact too much the result. Instead you will use a motor excitation on the Ratchet Wheel and study the motion of the Pawl. After running the scenario Mechanical Systems Experience, you will extract the traces of the pawl to improve the design. You will replace the motor by a position motor to rotate the wheel in both direction in order block the ratchet wheel with the pawl. To obtain good result you will play with the penetration max of the Simpletic Euler mode. Enjoy and remember to stay home! Hope this video will be helpful for you to learn more about 3DExperience :D Please Like, Comment, Share and Subscribe ;)
Small

Tutorial - CATIA DMU Kinematics Scissor Type Grab Bucket Simulation

1 0 Intermediate
Simulation of Scissor Type Grab Bucket using CATIA - DMU Kinematics module. 3D Design - https://grabcad.com/library/scissor-type-grab-bucket-model-1
Small

Planetary Gear Animation

1 0 Beginner
Solidworks Tutorial of Planetary Gear modeling and animation analysis.
Small

amazing door design in solidworks

1 0 Beginner
if anybody want the cad file checkout models in my profile
Small

How to analyse any 2D sketch mechanism in solidworks

1 0 Beginner
in this video you will learn how to make any 2d sketch mechanism in solidworks and analyse its various aspects like velocity and acceleration in solidworks by using motion analysis
Small

Tutorial - CATIA DMU Kinematics Jet Engine's Variable Inlet Guide Vanes(VIGV) Simulation

0 0 Intermediate
A gas turbine engine in which the angle of the inlet guide vanes can be changed to meet the requirements of the engine-operating conditions. These are normally in front of the first stage of an axial compressor and sometimes in the subsequent stages as well. Normally, they are closed during engine starting and low RPM, but they open progressively as the RPM is increased. At low RPM, the angle of attack of the low-pressure blades is kept moderate to avoid stalling. Variable-inlet guide vanes are not common in front of the turbine. 3D Design VIGV - https://grabcad.com/library/jet-engine-s-variable-inlet-guide-vanes-vigv-1 3D Design Jet Engine - https://grabcad.com/library/jet-engine-with-afterburner-model-1