Please send me message if you have problems with the tutorials, I'm trying to help everyone.
draw a spline between these points
go to left view and make your spline like this
go to top view and enter shown values for the spline handle
now open a sketch on the plane 1
draw shown circles
use 3d sketch again and draw a spline between shown points
make your spline handles like this
enter shown values for shown handle
now we will use loft command
select shown circle
then select shown bigger circle. dont forget to click on tick
now click on the centerline parameters box
select the 3D spline for centerline
confirm that. right click on the skecthes and show them
I cannot get the Loft function to work? i only get the circular surface but not the lines? could you help?
yeah thanks ... it worked out, i just didn't give it right end points. thank you guys
I didn't understand your question Shabbir, could you give more information about the problem?
haii i faced the same problem too but the actual problm is that we are using the guide curves and it is specified in the tuto that we have to use the centerline parameter
How can I make this section with catia ?
Thank you in advance