Learn about the GrabCAD Platform
Get to know GrabCAD as an open software platform for Additive Manufacturing
Visit our new homepage
Home
Control
Shop
Streamline Pro
Partner Program
Print
Community
Log in
Library
Challenges
Groups
Questions
Tutorials
Engineers
Blog
Log in
James Drewnicki
If you're going to do something, do it right
Follow
Hire me
7
followers
Shropshire, United Kingdom
Models
About
Models
20
Tutorials
0
More
Followers
7
Following
1
Likes
4
Following
1
Followers
7
Likes
4
Models
Sort by:
Recent
Recent
Popular
Most liked
Most commented
Most downloaded
Small electric motor
This is the motor we used for our water powered electricty generator project. I couldn't find one on GrabCAD at the time so had to make one and now...
16
441
4
Water Turbine Electricity Generator
Another Masters project to design a small scaled water turbine for a developing country
9
247
3
W12 Engine (kind of)
This was a first year project where we were asked to design an engine. Me being me and living by "go big or go home" I decided to try and design a ...
2
58
1
Mine Capsule
This was a project we had in our first semester of our Masters. It was to redesign the Phoenix II Rescue Capsule that was used in the 2010 Chilean ...
1
46
0
Moustrap Car
This was a project we did in our first year. It was to design a mousetrap car to move along a 5m track as quick as possible
8
73
2
Motocross Ramp
I had every intention of building this but had no money to do so
1
76
1
Full Cassette Parasolid
It's basically the assembly of the 2 chain ring holders, spacers, universal chain ring and 11 - 16 tooth sprocket
15
590
0
Non Drive Side Crank
Non Drive Side Crank (180mm)
1
34
0
Drive Side Crank
Drive side crank (180mm)
2
51
0
Rear Derailleur
It's not perfect (in fact it's quite bad) but they are pretty hard to make so obviously feel free to download it and edit it
9
489
0
Front Hub - Hope Pro 2
It's a front hub, and I'm pretty sure it's modelled from a Hope Pro 2 evo hub (it's been about a year and a half since I modelled it so I could be ...
4
146
1
Rear Hub - Hope Pro 2
It's a rear hub, and I'm pretty sure it's modelled from a Hope Pro 2 evo hub (it's been about a year and a half since I modelled it so I could be w...
7
237
0
Front chainring
This can be put on the cranks
3
96
1
Brake mount sprocket
This can be mounted to a brake rotor mount on a hub. I still don't know why you would do this for anything other than a custom project like a Handc...
1
149
1
Spline
To be used with 11-16 tooth sprocket, spacers and the chainring holders. The fat end can be cut off to be used as a normal spline as this was used ...
3
109
0
Universal chainring
This can be used with the chainring holders. Design table has been used so that the chainring teeth amount can be changed. Uses a standard 12.7mm c...
2
201
0
Spacer
To be used with "Spline" to space out the 11-16 tooth sprockets
3
47
0
2 chainring holder
Holds two chainrings
2
56
0
11 - 16 tooth sprocket
Fits with "Spline", required spacers in between each sprocket
4
144
1
3 chainring holder
Holds 3 chainrings all with equal spacing
2
69
0
