3D-printer issue

Hello,

I am completely new to all of this and looking around for help.I was hoping to present a new puzzle printed in my new black PLA but instead I have to annoy you again by talking about my printer issues. A few pieces that I printed tomorrow worked out fine. After those I started several other prints which failed. After restarting the print I was convinced that it wasn't the file that was responsible for the problem. Thus I looked at my device and searched for something odd. On closer examination I noticed that on the other side the "golden" piece wasn't moving alone but somehow attached to the box. In addition, the black piece at the bottom of the axis should be more or less permanent and is a bit too high on the false axis.I had checked 3d animation video but don't know what to do to fix the issue ? .Does anybody have an idea? I went through many resources but did not find any solution for this issues. Please help me out.

Any help will be appreciated.
Thank you.

Answer
 
Comments 0

3 Answers

Most printers use leadscrews which is cheaper than ballscrews they tend to have some backlash effect, i actually had some issues with my own printer (da vinci jr) it was by default set to wrong z axis value. i set it up to 0.1mm compensation . Also notice that if you don´t have heated printer bed to use either paper glue to keep the workpiece to not slip and slide thus causing your print to fail. I came up with the idea to use reusable baking paper glued to the bed it makes your print stay on the bed while printing and it stills come of easy (keep in mind to not use this method if you have heated bed)

 
Comments 0

Generally 3d printers might face problems like

1. Filament slip ( either filament is not feed properly inside)
2. Filament stuck ( unprofessional way of removing the filaments leave some filaments inside the extruder)
3. Extruder not heating ( due to improper usage)
4.Levelling problem ( every printer might have allen key some can be automatically levelled from some type manual levelling required
5.Heated chamber must be closed if the printer as chamber it should not be kept opened
6.Power source there must proper power source as mentioned in printer specification

hints:

1. read your manual properlly
2. do according to the manual
3. dont skip any step
4. make sure file doesnt have any error
5. update the firmware regualrly
6. If you have purchased a printer ask for help with that particular printer's tech support
7. dont try to dismantle it yourself

 
Comments 0

Some additional information which may be helpful to post:
- The make/model of the 3D printer.
- Good photos so everyone can better visualize the the gold and black pieces.

 
Comments 0