Deep drawing simulation via Abaqus

So, I am trying to create a Deep Drawing simulation in Abaqus, I followed this tutorial:

and so far I did a good job.Now I need to show the results I got and I have problems when I want to:

- show the stress-strain diagram of the material
- show only the deformed part deformations in the 3D model for von Mises stress analysis

Also, I have issus with the following:
- Parts go a little bit through each other (I think it could be because of the mesh, or a graphic problem, but it looks terrible)
- I can not stop the tool which makes the deformation - it goes all the way down until it breaks the material

Can anyone help me a little bit with these topics? Thank you very much in advance.

Comments 0