Guide curve no.1 does not intersect with section no.1
I am trying to loft with guided curves, but when I apply the loft command, error message appear that "Guide curve no.1 does not intersect with section no.1" I have tried many many times to solve this issue but not successful,
Please guide
Best Regards.........
Irshad
2 Answer
well if your guide curve has lot of critical shapes then this might happen once try out by designing your guide curves again then this issue might be solved
regards
Mr_Frienchie
You may try to check the sketch plane's normal. They all should be normal on following direction.
