How to balloon a view with the same item number as in the part list's designated view

I've inserted a view of an assembly into my drawing, and I also inserted a view of an individual part (which is used in the assembly). I then created a parts list for the assembly. However, I can't seem to figure out how to make a balloon for the individual part so that it references the same number as it would when being called out in the assembly view. Is there any way to do this other than editing the balloon after placement?

Answer
 
Comments 0

1 Answer

I'm not sure if this is answer to Your Q. But the balloon numbers are in the same order as You place parts to Your assembly.

 
Comments 2