Vahid Mostofi

Primary Value

Question by Vahid Mostofi

Hi,
If you take a look at the attached picture, apparently it shows that you can edit dimensions (names and values) at the same time ? Is it just an edited pic or there is actually some place like this in Solidworks?

I know I can edit dimension names and values by double clicking them but that's one at a time.

Answer
 
Comments 0

1 Answer

Frank Dixon
Answered on 21 May, 2015 09:46 PM

it appears as though the image was edited to show all dimensions at once. to edit them, you either need a design table or click on them individually.

 
Comments 1