Feed

How to create this part in CATIA V5

Tutorial by özgür kesebir
Small

Tutorial ready.

  1. Step 1:

    Step1- Open new part and go generative shape design. Create sketch at XY plane and draw the same on picture.

  2. Step 2:

    Step2- Create a new plane with offset from XY plane with value 120mm.

  3. Step 3:

    Step3- Create new sketch to Plane.1 and draw the circle.

  4. Step 4:

    Step4- Create new sketch to YZ plane and project sketch.1(rectangle) and make projected line construction/reference element. And create a point on the right end of projected line. (marked with red elips)

  5. Step 5:

    Step5- Create new sketch to YZ plane and project sketch.2(circle) and make projected line construction/reference element. And create a point on the right end of projected line. (marked with red elips)

  6. Step 6:

    Step6- You will reach the these sketches which seen on picture.

  7. Step 7:

    Step7- Run multi-sections surface command and select sketch1. and sketch2 as a sections. Then relocate the closing points by right clicking them and selecting replace selection. then check the red arrow direction. next go to coupling tab and select Ratio. Complete multi-sections surface.

  8. Step 8:

    Step8- Run split command and divide multi-section surface with ZX plane.

  9. Step 9:

    Step9- Go: Start-->Mechanical Design--> Generative Sheetmetal Design.
    Set the sheet metal parameters as shown.

  10. Step 10:

    Step10- Run Hopper command and select split surface as a selection.

    Part completed.

Comments

Please log in to add comments