Feed

Tutorial - Modeling Eye End (joint) in SolidWorks?

Tutorial by Sudhir Gill
Small

Here is the tutorial.

  1. Step 1:

    Start SolidWorks in part mode.

  2. Step 2:

    Front plane>>Sketch.

  3. Step 3:

    Draw two circles of 100mm and 50mm dia.

  4. Step 4:

    Extrude it mid-plane by 60mm.

  5. Step 5:

    Front plane>>sketch.

  6. Step 6:

    Draw a box like this one.

  7. Step 7:

    Same extrude operation.

  8. Step 8:

    Fillet.

  9. Step 9:

    Fillet these edges at 50mm.

  10. Step 10:

    Right face>>sketch.

  11. Step 11:

    Draw circles like this at each corner of 20mm.

  12. Step 12:

    Extrude cut 60mm.

  13. Step 13:

    Select this face and then sketch.

  14. Step 14:

    While selecting the face click convert entities.

  15. Step 15:

    Revolved cut.

  16. Step 16:

    Use the line as the axis.

  17. Step 17:

    Right face>>sketch.

  18. Step 18:

    Draw a circle of 50mm dia.

  19. Step 19:

    Extrude it by 50mm.

  20. Step 20:

    Again right face>>Sketch.

  21. Step 21:

    Convert the edge.

  22. Step 22:

    Extrude cut with flip side to cut at 60º draft.

  23. Step 23:

    Then fillet that edge by 10mm.

  24. Step 24:

    We have the part.

Comments

Please log in to add comments