Feed

Tutorial - Modeling guide bracket in SolidWorks?

Tutorial by Sudhir Gill
Small

Here is the tutorial.

  1. Step 1:

    Top plane>>sketch.

  2. Step 2:

    Draw this profile.

  3. Step 3:

    Extrude it by 10mm.

  4. Step 4:

    Top face>>sketch.

  5. Step 5:

    Draw a circle of 40mm dia.

  6. Step 6:

    Extrude it by 35mm.

  7. Step 7:

    Top face>>sketch.

  8. Step 8:

    Draw this entity using rectangle.

  9. Step 9:

    Extrude it by 28mm.

  10. Step 10:

    Fillet.

  11. Step 11:

    Fillet the edges of the previous extrude by 10mm.

  12. Step 12:

    Top face>>sketch.

  13. Step 13:

    Draw two circles equal to the edges and concentric to them also.

  14. Step 14:

    Extrude it in both direction by 2mm and 30mm.

  15. Step 15:

    Top face>>sketch.

  16. Step 16:

    Draw three circles concentric.

  17. Step 17:

    Extrude cut by through all.

  18. Step 18:

    Side Face>>Sketch.

  19. Step 19:

    Draw a circle of 10mm dia.

  20. Step 20:

    Extrude cut by through all.

  21. Step 21:

    Top face>>Sketch.

  22. Step 22:

    Draw this profile.

  23. Step 23:

    Extrude it up to the bottom surface.

  24. Step 24:

    Repeat the same step for other side too.

  25. Step 25:

    Right Plane>>Sketch.

  26. Step 26:

    Draw two circles of 10mm dia.

  27. Step 27:

    Extrude cut >> through all in both directions.

  28. Step 28:

    And we have the part.

Comments

Please log in to add comments