Feed

Tutorial - Modeling Kunai in SolidWorks?

Tutorial by Sudhir Gill
Small

Here is the tutorial.

  1. Step 1:

    Top plane >> Sketch.

  2. Step 2:

    Draw this profile.

  3. Step 3:

    Exit the sketch and then again Top plane >> Sketch. Draw same profile.

  4. Step 4:

    Front plane >> Sketch.

  5. Step 5:

    Draw this profile. Exit the sketch.

  6. Step 6:

    Again Front plane >> Sketch and this profile. Exit the sketch.

  7. Step 7:

    Now we have four different sketches.

  8. Step 8:

    Click Lofted surface under surfaces tab.

  9. Step 9:

    Select the two sketches. Click OK and the first surface is generated.

  10. Step 10:

    Now generate a lofted surface b/w the edge of the surface and sketch. Use selection manager to form group.

  11. Step 11:

    Again create the 3rd surface with same step.

  12. Step 12:

    Final surface with the edges of surfaces.

  13. Step 13:

    Click Knit surface under surfaces tab.

  14. Step 14:

    Select all surfaces and check Try to form solid and click OK.

  15. Step 15:

    Now we can see that a surface is generated.

  16. Step 16:

    Right plane >> Sketch.

  17. Step 17:

    Draw a circle of 10mm dia.

  18. Step 18:

    Extrude it with outward draft and from the offset plane.

  19. Step 19:

    Front plane >> Sketch.

  20. Step 20:

    Draw a circle on the edge.

  21. Step 21:

    Revolve it about the center line.

  22. Step 22:

    Fillet the edges.

  23. Step 23:

    We have the kunai created.

Comments

Please log in to add comments