Import issue

I have drawn a two line with an arc connection both end points from both line then apply fix constraint on two line and then save as in igs format.Now open in CATIA V5 R19 .

C:\Documents and Settings\nishant\Local Settings\Application Data\DassaultSystemes\CATReport\Line_Arc.rpt

Input file: F:\BOSS\Arti Mam\delivered\Line_Arc.stp

PostProcessor version : CATIA Version 5 Release 19 GA
~~~~~~~~~~~~~~~~~~~~STEP OPTIONS~~~~~~~~~~~~~~~~~~~~~
General: Detailed report: Enabled
General: Validation Properties (VP): Enabled
General: Groups (Selection Sets): Enabled
General: 3D annotations: Enabled
Import: Continuity optimization of curves and surfaces: No optimization

Parameters for Validation Properties:
Volume and area max. Deviation (%) [ 0.01 - 10 ]: 1.000000
Centre of gravity max. Deviation : 1.000000

~~~~~~~~~~~~~~~~~~~~~~~HEADER~~~~~~~~~~~~~~~~~~~~~~~~
Originating System : CATIA V5 STEP AP203
Preprocessor version : CATIA Version 5 Release 19 GA (IN-10)
File Schema : CONFIG_CONTROL_DESIGN

============================================
Current V5 session scale is: 1
--------------------------------------------

======================================================

OK = Transferred
KO = Not transferred
NS = Unsupported
OUT = Out of size
DEG = Degenerated
INV = Invalid

------------------------------------------------------------
| Entity Type | OK | KO | NS | OUT | DEG | INV |
------------------------------------------------------------
------------------------------------------------------------
| Result | 0 | 0 | 0 | 0 | 0 | 0 |
------------------------------------------------------------

======================================================

Transcription time in seconds: 0.532000

Regards
Nishant

Answer
 
Comments 0

1 Answer