Feed

Tutorial - 2D Simplification Static analysis in SolidWorks

Tutorial by Sudhir Gill
Small

I had used Simulation for Assembly (Double Girder Overhead traveling crane). For contact we just defined the global component set of contacts. At start there were unwanted results. But after changing the geometry the result were as we wanted. :)
In case of dynamic we defined initial condition of velocity (.5m/sec) for crab and the load curve (Sine) for 15sec. :P It took 3 hours and the CWR file was about 5.5GB. :P We have the result for displacement, but when we clicked stress, the solidworks got out of memory and crashed. :P

  1. Step 1:

    1

Comments

Please log in to add comments