Feed

Tutorial: How to make engine part 28

Tutorial by Aykut Dana
Small

CYLINDER HEADS

  1. Step 1:

    Prepare yourself a cup of coffee, sit back in your chair and open a sketch on the top plane

  2. Step 2:

    draw a rectangle

  3. Step 3:

    extrude it by 12 mm

  4. Step 4:

    open a sketch on the top plane again

  5. Step 5:

    draw a circle

  6. Step 6:

    extrude it by 90mm

  7. Step 7:

    open a sketch on the top plane and draw shown circles

  8. Step 8:

    add these two circles to your sketch

  9. Step 9:

    open a sketch on the top plane and draw these two lines. they are for to create planes

  10. Step 10:

    use referance geometry--plane command

  11. Step 11:

    firstly click on the shown surface

  12. Step 12:

    then click on the line

  13. Step 13:

    enter 345 degrees

  14. Step 14:

    now go to other side and make same things for the new plane

  15. Step 15:

    enter 350 degrees at this time

  16. Step 16:

    open a sketch on the plane 2

  17. Step 17:

    draw shown sketch

  18. Step 18:

    use 3D sketch command

    next: http://grabcad.com/questions/tutorial-how-to-make-engine-part-29

Comments

Please log in to add comments