Tutorial - Modeling Flower in SolidWorks?
Here is the tutorial.
-
Step 1:
Front Plane>>Sketch.
-
Step 2:
Use Spline and make this sketch about a center line.
-
Step 3:
Mirror Spline about center line.
-
Step 4:
Again make a spline about the end points of the two spline tangent to them.
-
Step 5:
Exit the sketch. Right plane>>Sketch.
-
Step 6:
Make a spline sketch like this.
-
Step 7:
Exit the sketch. Curves>>Project Curve.
-
Step 8:
Select both sketches.
-
Step 9:
Now Filled surface.
-
Step 10:
Select the curve. Click OK.
-
Step 11:
Front plane>>Sketch.
-
Step 12:
Make a circle.
-
Step 13:
Trim Surface.
-
Step 14:
Trim the leaf about the circle.
-
Step 15:
Select the same sketch & then Extruded surface.
-
Step 16:
Extrude the surface.
-
Step 17:
While selecting front plane & Origin click Reference geometry>>Axis.
-
Step 18:
Create a planar surface about the edge of the extruded surface.
-
Step 19:
Thicken that edge.
-
Step 20:
Now pattern the leaf surface as a body about the axis.
-
Step 21:
Click Dome tool.
-
Step 22:
Select the Thicken Surface.
-
Step 23:
And we have the flower.