1 answer

• 
  Andrew Phil almost 3 years ago

  Some videos are into www.solidworks.com. How deep lessons you need? I have the book, but it in is russian...

  1. 
     Andrew Phil almost 3 years ago

     Unfortunately, i can only say how is possible... My SW don't support nonlinear studies.
     I think the first MAIN IMPORTANT step is to create a nonlinear material.
     But here is the main problem: when i am opening new just created non-linear material, it is linear again(((
     My software is "Simulation". I think i need "Simulation Premium" to make non-linear studies.
     Try to create a non-linear material. If your sw can do it, when the rest of steps are not hard.

  2. 
     islamCe almost 3 years ago

     i need to design punch and die to bend a sheet metal with different angle
     i need to simulate them
     and make tensile test on the sheet metal to know the force that will failure it
     can u help me a bout this?