Feed

Tutorial: How to make engine part 33

Tutorial by Aykut Dana
Small

CYLINDER HEADS

  1. Step 1:

    roll the line back up to shown place

  2. Step 2:

    open a sketch on the right plane

  3. Step 3:

    draw a centerline

  4. Step 4:

    draw shown sketch

  5. Step 5:

    mirror shown lines

  6. Step 6:

    add these lines

  7. Step 7:

    use trim command

  8. Step 8:

    draw one more centerline

  9. Step 9:

    add two circles

  10. Step 10:

    use trim command again

  11. Step 11:

    extrude it trought to two direction

  12. Step 12:

    open a sketch on the shown face

  13. Step 13:

    draw shown circles

  14. Step 14:

    draw same circles to other side

  15. Step 15:

    cut the body by 8 mm

  16. Step 16:

    roll the line forward

  17. Step 17:

    open a sketch on the right plane..

  18. Step 18:

    draw a centerline like shown

  19. Step 19:

    continue the sketch

  20. Step 20:

    finish your sketch like shown

  21. Step 21:

    use cut revolve command

    next: http://grabcad.com/questions/tutorial-how-to-make-engine-part-34

Comments

Please log in to add comments