Feed

Tutorial - Making iPhone 4s in SolidWorks Part 4?

Tutorial by Sudhir Gill
Small

Here is the fourth part.

  1. Step 1:

    Split line and project them on back face.

  2. Step 2:

    Inner face >> Sketch.

  3. Step 3:

    Convert the inner edge and extrude cut it by 0.50mm.

  4. Step 4:

    Dome it by 0.4mm.

  5. Step 5:

    Circular face >> Sketch.

  6. Step 6:

    Convert the edge.

  7. Step 7:

    Extrude it by .10mm and uncheck Merge result.

  8. Step 8:

    Bottom face >> Sketch.

  9. Step 9:

    Draw a slot.

  10. Step 10:

    Mirror it about a center line on origin.

  11. Step 11:

    Extrude cut by 1mm.

  12. Step 12:

    Left face >> Sketch.

  13. Step 13:

    Draw this slot.

  14. Step 14:

    Split line and then select inner face.

  15. Step 15:

    Bottom face >> Sketch.

  16. Step 16:

    Draw a rectangle.

  17. Step 17:

    Extrude cut by 2.5mm.

  18. Step 18:

    Chamfer the cut edge by 0.15mm at 45º.

  19. Step 19:

    Bottom face >> Sketch.

  20. Step 20:

    Draw two circles.

  21. Step 21:

    Split line and select bottom face.

  22. Step 22:

    Circular face >> Sketch.

  23. Step 23:

    Draw a 5 side polygon and construct star.

  24. Step 24:

    Repeat same step for other circular face. Make polygon construction.

  25. Step 25:

    Extrude cut by 0.50mm.

  26. Step 26:

    Here is fifth part.
    http://grabcad.com/questions/tutorial-making-iphone-4s-in-solidworks-part-5

Comments

Please log in to add comments